Masonry ladder & truss mesh

Masonry horizontal joint reinforcement mesh include ladder-type and truss type. Ladder type
reinforcements are designed to be embedded in the horizontal mortar joints of masonry walls. It
consists of two parallel side rods with cross rods welded at 16” (400 mm) O. C., thus forming a
ladder configuration. Overall measurement (side-to-side rod) is approximately 2” (50 mm) less
than the nominal wall thickness.truss type reinforcement designed to be embedded masonry wall. It
consists of 2 side-rods welded to a continuous diagonal formed cross-rod forming a truss design
with alter nating welds not exceeding 8” (200 mm) O. C. overall. For use in single-wythe walls.

• 
• 

• Standard Length	Width	Finishes
  10’(3.05m)	2”(50mm)	Uncoated Electro Galvanized Hot Dipped Galvanized After Fabrication Stainless Steel
  	4”(100mm)
  	6”(150mm)
  	8”(200mm)
  	10”(250mm)
  All products conform to: ASTM A641 - (Electro  galvanized ) ASTM A153 Class B2 - (Hot dipped after fabrication) ASTM A 82 - (Cold drawn steel wire) Tensile Strength:80,000 PSI;Yield Point:70,000 PSI minimum;Reduction of Area:30 %. ASTM A951-96 - (Masonry wall reinforcing) ASTM 580 Type 304 - (Stainless steel)